Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Well...that's annoying....
-
In good time. There is still a budget that needs to be maintained and a Mustang that needs to be brought back to life as well.
- Likes 1
Leave a comment:
-
I've got the .68 fifth gear. As it sits, fifth is unusable. With a 3.73 and LSD, the speed range will be ideal. Until the engine is built up, there's...
Leave a comment:
-
Actually, have a different pathing now. Got in touch with a gentleman who will be taking my stock axle and re-gearing it. The process will happen towards...
- Likes 2
Leave a comment:
-
Maybe not. The Chrysler 8.25 axle was used through at least 1996 in trucks, vans, XJ Cherokees and oddly enough, Jeep Liberty. If the measurements between...
- Likes 1
Leave a comment:
-
Everything is where it should be. Been tuning the engine to get as much power out of it as possible to offset the fact that I've got a five-speed and...
- Likes 1
Leave a comment:
-
It's moving under its own power! Drove it 46 miles today (I've got a loop that is 23 miles of farm roads around my house).
- Likes 5
Leave a comment:
-
Actual bloodshed, none. Now, considering the contents of the transmission, the amount of blood-colored fluids all over the floor of my shop, you'd swear...
Leave a comment:
-
Positive: The car did move under its own power.
Negative 1: Bearing was shimmed wrong.
Negative 2: Broke the f'king bearing...
- Likes 1
Leave a comment:
-
I've had my fair share of hydraulic bearing fun. Remember my 2012 Cruze and the hell that little econobox brought me? But it's American Powertrain. I'm...
- Likes 1
Leave a comment:
-
Pulled everything apart to clean up the cuts on both the hole and the brace. Primed and painted bare metal. Installed fitment ring into bellhousing (it's...
- Likes 2
Leave a comment:
No activity results to display
Show More
Leave a comment: