Engine Bearings, who makes custom ones.......

[TC]

Well I sent an Email to Clevite and the response was well, bad and good........Basically they do not make the CB1798H in a .010 undersize, so they said to not give up and contact some of the other Bearing Manufacturers out there...... It was that or I could put an order in for 1000 bearings which would have a 12-16 week turn around, but man how much do you think that would cost??............

So who are the other bearing manufacturers that I could try??

[JeffMcKC]

PM Jay (Warpspeed) on here, he works in Hedricks engine shop, Yeah that Hendricks, he should be able to help you out as to where to buy what you need.

[Orange65]

You could always hard chrome the crank back up to stock size! Might be the least expensive way...

[TC]

You could always hard chrome the crank back up to stock size! Might be the least expensive way...

Never even thought of that.... I'll definitely keep that in mind!!!.....

[TC]

PM Jay (Warpspeed) on here, he works in Hedricks engine shop, Yeah that Hendricks, he should be able to help you out as to where to buy what you need.

Jeff you sure you got the name right, I PM'd Warpspeed, but it wasn't Jay..........You thinking YB??

[JeffMcKC]

I thought he used the same name here, use the YB then or Jake can call him......

I think Scott knows some guys at Roush he might be able to find out also

[JeffMcKC]

http://www.bangshift.com/forum/showt...us-Oxide/page4

I think he uses the same name

[TC]

http://www.bangshift.com/forum/showt...us-Oxide/page4

I think he uses the same name

That Warpspeed is in Australia, but the guy over at the YB with the same name looks like the one your talking about........ I'll give him a PM....

[Beagle]

Did you ever mic this thing? STILL NEED TO KNOW! Lol.

King Alecular
If it's a Sonny Bryant crank, I'd give them a call.

[SpiderGearsMan]

umyeah