Test
My 409/'55 Chevy Project
Collapse
X
-
Well the header project fell flat on it's face.
The shop that was going to do the project was all hat and no cattle.
I finally had to go pick the headers up........I did tweak a couple of tubes.
Sent them off to Jet Hot........did a great job on the exterior but they failed to
coat the insides. All I got was a 'shit happens'.
I think I'm snake bit sometimes.
Got the heater core replaced and MSD sent me back my distributor all nice and clean......hopefully no more rust issues.
Got a set of chrome reverse coming for the rears and am looking strongly at maybe
a hydraulic clutch.
Before

After

Headers Coated
Thom
"The object is to keep your balls on the table and knock everybody else's off..."Comment
-
Yeah......too far for sure.Originally posted by malc View PostMy MSD distributor gets like that too, they advised me on their website to send it to them..................too far/too costly.
I think they charged me like $69 for the re do.
You'd be better off to just pop the cap and clean it yourself.Thom
"The object is to keep your balls on the table and knock everybody else's off..."Comment
-
that'll be a nice look!Patrick & Tammy
- Long Haulin' 2008, 2009, 2010, 2011, 2012, 2014...Addicting isn't it...??Comment
-
Sticking with the SS Cragars for now......still a good '60's vibeOriginally posted by malc View PostWhat type of wheels will you be running up front ?
Hopefully some photos to follow later this weekLast edited by Monk; March 10, 2014, 04:02 PM.Thom
"The object is to keep your balls on the table and knock everybody else's off..."Comment
-
my pants are getting tight....If you can leave two black stripes from the exit of one corner to the braking zone of the next, you have enough horsepower. - Mark DonohueComment
-
-


Comment