Originally posted by CueBall
View Post
Announcement
Collapse
No announcement yet.
What does your car need b4 the power tour?
Collapse
X
Collapse
-
Originally posted by 502ChevelleSS View Post
Well took driveshaft out to local shop and what do ya know? My " brand new driveshaft" wiggles worse than a 2 dollar whore in church on sunday. I am having new one built and ready for pick up on Friday. Fingers crossed that solves my problems. Now to figure out gas gauge problem......
Comment
-
Originally posted by Redline04 View PostPowermaster was not good, but cannot find that post anymore.
I'd like to find one with at least 80-100 amps output. Recommendations?I have ADD with a lazy feature.....according to my wife!
Comment
-
Originally posted by 74NovaMan View Post
I've not worked on any Camaros of that vintage but I seem to recall my 73-74 Novas having a 2 piece fuel line from the factory. That being said, I should probably check the rubber section by the tank as well as the one in the middle. They're probably originals....when you got a fast car, you think you've got everything.
http://www.youtube.com/watch?v=ZpvfmSL6WkM
Comment
-
Motor is back in. Pilot bearing had exploded. Glad l found that out. New gas tank straps inatalled. New fuel gauge inatalled. Relay for sending unit changed, it was dead....Found header gaskets had a slight leak. Installed new ones. Installed new NFL spark plugs..since I had the motor out. Freshener up paint on water pump and balancer. NOW, I shod be able 2 get out and drive.....WHEW....69 SS
- Likes 2
Comment
-
Originally posted by 502ChevelleSS View Post
Now to figure out gas gauge problem......
I R Bob
You can't drink all day unless you start in the morning!
2007 LH, 2008 LH, 2009 LH, 2010 LH, 2011 LH, 2012 DNF/BLOW'D UP, 2013 LH, 2014 LH
Comment
-
Was having a starter problem on the Pinto for awhile now. The solenoid keeps hanging up and the starter stays engaged . It gets so hot it melts the insolation off the cables and the battery fills like it's going to explode. Then it wouldn't do it for awhile and then out of the blue it acts up again. I changed the starter and the solenoid three times added more grounds cleaned all the old grounds. Thought the problem was gone then I took her to Indy she fine there and back got home went to pull her into the garage and boom it rears its ugly head again. So I change the solenoid again fries it right away go get a heavy duty one same thing. Then I done some research and found out that if you have a high torque starter you have to have a high torque starter solenoid. I got on line and found one installed it tonight problem solved. She cranks over so fast now and sounds a whole lot different.Greg & Mendy Dayton, Ohio 2007LH 2008LH 2010LH 2011LH 2012 1st 2 stops 2013LH 2015 1st 2 stops2016LH 2017 first and last stops . 2018 LH ("It's better to be dead and cool than alive and uncool!! Harley Davidson!")
- Likes 2
Comment
-
New stainless gas tank & line installed but ran out of time tonight to go get gas & check everything out....when you got a fast car, you think you've got everything.
http://www.youtube.com/watch?v=ZpvfmSL6WkM
- Likes 2
Comment
-
Add me to the "fixed gas tank problem" crew. I replaced the tank, pickup sock, and sender wires a few weeks ago. When I filled the tank last week, gas gushed out the top of the tank when I filled it. The other night I was able to drop the tank and found out that the rubber seal had a kink in it, so the fuel would just pour out if you filled above the top of the tank (fuel in the filler neck). I removed the sender, put the seal back on straight, and put it all back together, being very careful to keep the rubber in the groove. No more leak, so that's done.
Tried to pull my steering wheel last night and just ended up gouging the plastic. Gonna have to rent a different puller, because the one I got from O'Reilly just isn't going to work. Hopefully I can do that tonight and also drain the rear end oil. I'd like to change that before I leave.
- Likes 3
Comment
-
I'm not sure I am definitely in that "crew" yet. I had enough time to dump a couple gallons of gas in tonight & move it into the street while I played musical cars in the garage & driveway. And then back into the driveway for the night. No obvious leaks but nowhere near full yet. I am reasonably certain that the rubber seal is in correctly as I have done them before. But I did not think that the aftermarket lock ring went as tight as I think that it should have. The ones that I have done with NOS pieces seemed to be tighter. I should be able to fill it tomorrow & then we will find out....when you got a fast car, you think you've got everything.
http://www.youtube.com/watch?v=ZpvfmSL6WkM
- Likes 2
Comment
-
Ok. It's me AGAIN....Gas tank sending unit ground was NOT tight. And NOT shrink wrapped exposing a bit of bare wire....SO, IMO that's why the fuel gauge was erratic. New gauge & Sending unit installed..Looking to get some real miles in on Sunday...Coil overs adjuatment knob set to 9 clicks. Gonna see how that feels and go from there...69 SS
- Likes 4
Comment
-
Ran the nut and bolt check....good.... couple hundred miles on all kinds of paved surfaces with no major issues.... just an O2 sensor code... normal since the header install... handles like an extension of your brain.... trans shifts tight and didn't hit more than 150 degrees... Excellent! needs new valve stems and an alignment check with an underbody nut and bolt check....Last edited by silver_bullet; May 28, 2017, 03:52 AM.Patrick & Tammy
- Long Haulin' 2008, 2009, 2010, 2011, 2012, 2014...Addicting isn't it...??
- Likes 1
Comment
-
Originally posted by A BAD SS View PostOk. It's me AGAIN....Gas tank sending unit ground was NOT tight. And NOT shrink wrapped exposing a bit of bare wire....SO, IMO that's why the fuel gauge was erratic. New gauge & Sending unit installed..Looking to get some real miles in on Sunday...Coil overs adjuatment knob set to 9 clicks. Gonna see how that feels and go from there...
Comment
Comment